2008 Polaris Ranger RZR Service Manual, Page 42Get this manual
MAINTENANCE Toe Adjustment
If toe alignment is incorrect, measure the distance between vehicle center and each wheelThis will tell you which tie rod needs adjustingNOTE: Be sure steering wheel is straight ahead before determining which tie rod(s) need adjustmentSuspension Spring Adjustment 123Position the vehicle on level surfaceStop the engineRaise and safely support the front or rear of the vehicle off the ground to allow the suspension to fully extend
NOTE: The tires should not be touching the ground4To adjust the suspension, use the adjustment cam located near the bottom of the shock
CAUTION
During tie rod adjustment, it is very important that the following precautions be taken when tightening tie rod end jam nutsIf the rod end is positioned incorrectly it will not pivot, and may break
Shock Spanner Wrench (PN 2870872)
5Rotate the adjustment cam clockwise to increase spring tension or counter-clockwise to decrease spring tension
To adjust toe alignment: Hold tie rod end to keep it from rotating Loosen jam nuts at both ends of the tie rod Shorten or lengthen the tie rod until alignment is as required to achieve the proper toe setting as specified in Toe Alignment Inspection IMPORTANT: When tightening the tie rod end jam nuts, the rod ends must be held parallel to prevent rod end damage and premature wearDamage may not be immediately apparent if done incorrectly After alignment is complete, torque jam nuts to specification