2008 Polaris ATV Outlaw 450/525 Service Manual, Page 90Get this manual
BODYSTEERINGSUSPENSION 11Press bearing into place until outer race bottoms on housing
UpperLower Control Arm Bolt Torque: 33 ftlbs(45 Nm)
6789Pull drive shaft outward and install hub onto driveshaft splinesInstall cone washer domed side facing outwardInstall retainer nut, wheel and wheel nutsRemove jackstand and torque hub nut and wheel nuts to specification
CAUTION
Use an arbor press and only press on the outer race of the bearingFailure to do so, will result in bearing damage12Install snap ring into groove
90 ftlbs(122 Nm)