2008 Polaris ATV Outlaw 450/525 Service Manual, Page 47Get this manual
MAINTENANCE Rear Shock Rebound Adjustment
The rebound damping adjustment is located between the lower spring seat and lower shock eyelet mount of the rear shockUse flat blade screwdriver to make damping adjustmentsNOTE: When the adjuster screw is turned clockwise until it stops, the damping is in the fully closed positionTurn the clicker clockwise to increase compression dampingTurn the clicker counter-clockwise to decrease compression dampingNOTE: The factory setting is 16 clicks from closed (see "Rear Rebound Adjustment Table")
SUSPENSION (525 "IRS")
Front Suspension Set-Up
123Position the vehicle on level surfaceStop the engineElevate the front of the vehicle by placing suitable jack stand under the frame
NOTE: The tires should be barely touching the ground and the suspension should be at full rebound4Measure the distance from the ground to the bottom of the lower front bumper boltNote this measurement for later use
Clicker Adjuster