2007 Polaris Sportsman 700/800/800 X2 EFI Service Manual, Page 341Get this manual
ELECTRICAL Crankshaft Position Sensor Gap
Measure trigger coil gap with feeler gaugeThe gap should be .059 inch (1.0 mm)
CHARGING SYSTEM
Current DrawKey Off CAUTION
Do not connect or disconnect the battery cable or ammeter with the engine runningDamage will occur to electrical componentsConnect an ammeter in series with the negative battery cableCheck for current draw with the key offIf the draw is excessive, loads should be disconnected from the system one by one until the draw is eliminatedCheck component wiring as well as the component for partial shorts to ground to eliminate the draw
Crankshaft Position Sensor Gap: .059"#! .010 inch (1.0.26 mm) Ignition System Troubleshooting