2007 Polaris Sportsman 700/800/800 X2 EFI Service Manual, Page 246Get this manual
FINAL DRIVE 8While pulling out on the CV shaft, fully extend the CV joint and slide straight O-ring pick or small slotted screw driver between the small end of the boot and the shaftThis will allow the air pressure to equalize in the CV boot in the position that the joint will spend most of its lifeBefore you remove your instrument, be sure the small end of the boot is in its correct location on the axle
INSTALLATION
1Slide shaft assembly into bearing carrier hub
2349Install the small clamp on the boot10Be sure to use only the Constant Velocity Joint grease supplied with boot service kitIF CV JOINT WAS CLEANED, add the recommended amount of grease to the joint in addition to the grease pack supplied with boot kitNOTE: CV Joint Grease Capacity: Joint Capacity 50 grams