2007 Polaris Sportsman 700/800/800 X2 EFI Service Manual, Page 108Get this manual
ENGINE 37Install water pump impeller (P)Secure the impeller with the washer and new nylok nut (Q)Torque the nut to specification39Sparingly apply Starter Drive Grease (PN 2871423) to the starter driveInstall the starter bendixNOTE: There are thrust washers on both sides of starter drive
Water Pump Impeller Nut Torque: 108inlbs(6.80.68 Nm) 38Install water pump cover (R) with new O-ring sealTorque bolts to specification in proper sequence (See front of this chapter)
40Install stator assembly (S) and boltsTorque bolts to specification41Install the wire hold down bracket (T)Install two new wire hold down boltsNew bolts contain patch-lockTorque bolts to specification, following the proper bolt torque sequenceCoat the stator wire grommet (U) with Nyogel (#Grease (PN 2871329)NOTE: Verify stator wires are routed properly under the wire hold down bracket