2005 Polaris Sportsman 400/500 Service Manual, Page 211Get this manual
FINAL DRIVE
REAR DRIVE SHAFT SERVICE
1Remove clamps from rubber boot(s) using the CV Boot Clamp Pliers (PN 8700226) (A)
Spread ends of snap ring to remove joint from shaft
Tap CV Housing Off Shaft 4Place new snap ring in the groove of the CV joint inner hub, with tabs facing the shaft as shown
2NOTE: Photo below is shown without shaft for clarityWipe grease away from recess in CV joint inner hub to locate snap ringSnap ring located in recessed area