2005-2007 Polaris Ranger 500 service manual, Page 294Get this manual
ELECTRICAL Headlamp Housing Installation
12To install the headlamp housing, press the headlamp tabs back into the bracketsSecure the headlamp housing with the rubber O-rings on each side (A)Install the adjustment screw (B)
TAIL LIGHTBRAKE LIGHT
Lamp Replacement
Before replacing the tail light, use digital multi-meter to test the harness to ensure the lamp is receiving 12 volts and that ground path is presentIf the tail lightbrake light does not work the lamp assembly may need to be replaced1From the rear of the tail light remove two screws holding lens cover in place and remove lens cover(T-20 Torx)