2005-2007 Polaris Ranger 500 service manual, Page 246Get this manual
TRANSMISSION Adjustment
1Place gear selector in neutralMake sure the transmission bell crank is engaged in the neutral position detents
TRANSMISSION SERVICE
Transmission Removal
12Neutral Position Remove the PVT system from the left side of the transmissionDrive roll pin from rear driveshaft yoke
NOTE: On the 4x4 transmission the front output shaft yolk slides off during the transmission removal4x4 Shown Roll Pin Removal Tool
With two wrenches loosen the outside jam nut counterclockwiseTurn the outside jam nut 12 turnsPerform this procedure on the shift lever end, alsoInside Jam Nut