2005-2007 Polaris Ranger 500 service manual, Page 234Get this manual
FINAL DRIVE REAR PROPSHAFT
Removal
1Remove the pin clips from upper and lower cargo box shock pins and remove shockCarefully allow cargo box to rest in the dump position as you remove the propshaft4Slide the propshaft off the transmission shaft and rear gearcase input shaftOrientate the shaft so that it's parallel with the frame supports as shown belowRemove the shaft by placing the brake disc over the top of the rear frame support and under the front frame supportRear Frame Support
WARNING
Support the cargo box while the shock is removed to prevent injury or damage2Use the Roll Pin Removal Tool (PN 2872608), to remove the roll pin from prop shaft at rear of transmissionFront Frame Support