2005-2007 Polaris Ranger 500 service manual, Page 233Get this manual
FINAL DRIVE Installation
1Slide the rear drive axle into the bearing carrier hub4Lift bearing carrier into place and install the bolt into the upper control armTorque bolt to 30 ftlbs(41 Nm)
30 ftlbs(41 Nm)
Install new circlip onto the rear drive shaftApply AntiSeize Compound onto the rear driveshaft splines (both ends)Install hub, domed washer (domed side out) and nutTorque rear spindle nut to 110 ftlbs(149 Nm)Install new cotter pin and hub cap
Apply Anti-Seize