2005-2007 Polaris Ranger 500 service manual, Page 231Get this manual
FINAL DRIVE CV JointBoot Replacement
1Remove clamps from rubber boot(s) using the CV Boot Clamp Pliers (PN 8700226) (A)A NOTE: When replacing damaged boot, check the grease for contamination by rubbing it between two fingersA gritty feeling indicates contaminationIf the grease is not contaminated, the boot can be replaced without cleaning the CV jointUse the recommended amount of grease for boot replacement only45Remove boot from the shaftThoroughly clean and dry the CV joint and inspect ball tracks and cages for wear, cracks or other damageNOTE: Shiny areas in ball tracks and on the cage spheres are normalDo not replace CV joints because parts have polished surfacesReplace CV joint only if components are cracked, broken, worn or otherwise unserviceable