2005-2007 Polaris Ranger 500 service manual, Page 222Get this manual
FINAL DRIVE 10Use flat head screwdriver to remove the retaining ring from the output coverRetaining Ring 13Remove the output hub (G) from the coverremove the thrust bearing (F) from the output hub (G)Inspect the thrust bearing (F) and the dowel (H)H G
F 11Remove the spacer washer (D), armature plate (E), and rubber O-ring from the output coverD O-Ring
14Inspect the magnetic coil (I) in the output housingNOTE: See "FRONT GEARCASE DIAGNOSIS" earlier in this chapter for more details on the coil15Inspect the back lash pad (J) for excessive wearNOTE: The backlash for the centralized hilliard is set at the factoryNo adjustment is required, unless the front cover needs to be replaced, or the back lash pad screw is removedSee the "Backlash Pad Adjustment" procedure later in this chapter for details on backlash settingJ