2005-2007 Polaris Ranger 500 service manual, Page 220Get this manual
FINAL DRIVE 5Inspect the rollers for nics and scratchesThe rollers must slide up and down and in and out freely within the roll cage sliding surfaces8The front gearcase and drive shafts can be accessed from both sides of the vehicle and limited access from the top
Rollers
Top ViewFrom under hood 9Remove the access panel on the side of the vehicleT-25 screws secure the panel to the frame
Gearcase Removal
123Stop engine, place machine in gear and set parking brakeLoosen right front wheel nuts slightlyElevate and support machine under footrestframe area
CAUTION
Serious injury may result if machine tips or fallsBe sure machine is secure before beginning this service procedureWear eye protection when removing and installing bearings and seals45Remove right wheel nuts and wheelRemove cotter pin, lower ball joint nut, and A-arm from ball joint