2005-2007 Polaris Ranger 500 service manual, Page 198Get this manual
CLUTCHING 3Remove ramp buttons from moveable sheave678Install sheave onto pullerInstall nut onto puller rod and tighten by handTurn puller barrel for further tension if neededTurn clutch sheave counterclockwise until bushing is removedRepeat Stepsfor other bushingUsing an appropriate heat gun, apply heat directly on bushing until tiny smoke tailings appear
CAUTION
Clutch components will be hot! In order to avoid serious burns, wear heat resistant insulated gloves for the rest of the removal process9Remove nut from puller rod and set aside10Remove adapters from puller11Remove bushing and removal tool from adaptersDiscard bushing