2005-2007 Polaris Ranger 500 service manual, Page 172Get this manual
BODYSTEERINGSUSPENSION 11Remove the bottom stabilizer bar nut14Install new A-arm assembly onto vehicle frameTorque new bolts to 30 ftlbs(41 Nm)
WARNING
Stabilizer Bar The locking features on the existing bolts were destroyed during removalDO NOT reuse old boltsSerious injury or death could result if fasteners come loose during operation15Attach A-arm to wheel bearing carrierTorque upper and lower carrier bolts as shown16Install the shock and tighten shock bolt to 30 ft.lbs(41 Nm)17Re-install wheel and caliperRefer to "Chapter 2" for wheel toque specifications
12Loosen two bolts that secure the A-arm bushing to frame by alternating each about 13 of the way until the A-arm can be removedThe lower A-arm should now be free to removeA-Arm Installation 13Insert new A-arm bushings and new A-arm shaft into new A-arm