2004 Polaris Sportsman 700 EFI ATV Service Manual, Page 66Get this manual
ENGINE VALVE SEAT RECONDITIONING CONT'D If the contact area of the cutter is in the same place, the valve guide is distorted from improper installationG If the contact area of the initial cut is greater than 75, continue to cut the seat until all pits are removed and new seat surface is evidentNOTE: Remove only the amount of material necessary to repair the seat surface5To check the contact area of the seat on the valve face, apply thin coating of Prussian Bluet paste to the valve seatIf using an interference angle (46apply black permanent marker to the entire valve face (A)G If the seat is too narrow, widen using the 45 cutter and re-check contact point on the valve face and seat width after each cut
NOTE: When using an interference angle, the seat contact point on the valve will be very narrow, and is normal conditionLook for an even and continuous contact point all the way around the valve face(B) (B)