2004 Polaris Sportsman 600/700 Service Manual, Page 117Get this manual
CARBURETOR ASSEMBLY CONT'D 5Install the pilot mixture screw, spring, washer, and O-ring as an assemblyLubricatethe O-Ring with oil or light grease before installationCAUTION: Do not damage the -ring during installationTum the screw in until it lightly contacts the seatBack Qui the specified number of turnsNOTE: The final pilot (idle) mixture must be adjusted with 3If adjustment is necessary, bend the tongue slightlyBe sure float measurement is even on left and right side
the engine runningRefer to Page NO TAGPilot Mixture Screw Base Setting (Set at Factory) Refer to Specifications Page In Chapter 1
FLOAT HEIGHT ADJUSTMENT
1Place the carbu retor on level surface as shown at right to remove weight from float armIn this position, the float tongue will rest lightly on the inlet needle valve pin without compressing the spring