2003 Polaris Sportsman 600, 2002-2003 Polaris Sportsman 700 Service Manual, Page 245Get this manual
ELECTRICAL 6Install clear battery vent tube from vehicle to battery ventWARNING: Vent tube must be free from obstructions and kinks and securely installedIf not, battery gases could accumulate and cause an explosionVent should be routed away from frame and body to prevent contact with electrolyteAvoid skin contact with electrolyte, as severe burns could resultIf electrolyte contacts the vehicle frame, corrosion will occur7Route cables so they are tucked away in front and behind battery
HIGH BEAM HEADLIGHT LAMP REPLACEMENT
CAUTION: Do not service while headlight is hotSerious burns may resultProtect lamp during installPosition knob in slot and secure in locking tabs Snap pins into tabs Slip O-Ring over pin
HIGH BEAM HEADLIGHT ADJUSTMENT
The headlight beam can be adjusted to any position desired by turning the adjusting knob located on the bottom right side of the headlight pod1Place the vehicle on level surface with the headlight approximately 25 (7.6 m) from wall25 (7.6 m) Lamp Center Height
Adjustment Knob Stop