2001 Polaris Sportsman 400-500 DUSE and H.O. Service Manual, Page 336Get this manual
ELECTRICAL
HIGH BEAM HEADLIGHT ADJUSTMENT
The headlight beam can be adjusted to any position desired by turning the adjusting knob located on the bottom right side of the headlight pod1Place the vehicle on level surface with the headlight 25' (7.6 m) approximately 25' (7.6 m) from wall2Measure the distance from the floor to the center of the headlight and make mark on the wall at the same height3Start the engine and turn the headlight switch to high beam4Observe headlight aimThe most intense part of the headlight beam should be aimed (5.1 cm) below the mark placed on the wall in step NOTE: Rider weight must be included on the seatOn machines with separate low beam lights, the drop should be (20.3 cm) in 25' from the center of the low beam lamp5Adjust beam to desired position Lamp Center Height
HIGH BEAM HEADLIGHT LAMP REPLACEMENT