1985-1995 Polaris ATV and Light Utility Hauler Service Manual, Page 265Get this manual
ENGINES Engine Service, 350Ll400L NOTE: To reassemble engine, reverse the following procedure, paying attention to reassembly notes as indicated1Refer to page 7.28 and follow engine removal instructionsThis engine will also require removal of coolant lines and the sending unit wire mounted at the rear of the cylinder headRemove the six bolts retaining the starter assembly and flywheel coverReassembly Note: During reassembly apply Loctite 515 to mating surfaces of starter cover assembly and crankcase assemblyRemove starter pulley (350L only) and flywheel nutFor starter removal, remove bolts retaining starter bracket on PTO side and two bolts (A) on mag sideNOTE: If starter inspection is necessary, make sure during reassembly that the gear shaft washer (B) is in place between the gear shaft assembly and starter motor for reassemblyStarter damage will occur if this washer is not correctly pOSitionedFor detailed service and repair of electric starters and starter drives, refer to Chapter of this Service Manual