1985-1995 Polaris ATV and Light Utility Hauler Service Manual, Page 171Get this manual
TRANSMISSION Selector Installation Selector Installation 1Place gear shift selector back into the mounting bracket and replace three bolts2Reconnect linkage rods to gear shift selector slidesAdjust as requiredSee linkage adjustment procedures3Route gear shift selector switch wiring harness properly and secure in place with cable ties4Reconnect the wiring harness leads to the terminal boardFollow the color codes when installing wire leads to terminal board5Using cable ties (PN 7080138), secure the gear shift selector switch wiring harness to the frame6Install fuel tank7Replace the fuel tank cover and side panels8Remount the exhaust pipe using high temp silicone to seal jOints9Connect the springs10Replace rear cab and heat shieldReattach cab to frame11Secure heat shield to frame with two screwsTerminal Board (Except 1995 Scrambler and Xplorer)
Boot Replacement
NOTE: If the selector boot is damaged, or if moisture is found in the gear shift selector the boot should be replaced