1985-1995 Polaris ATV and Light Utility Hauler Service Manual, Page 104Get this manual
BODY, STEERING AND SUSPENSION Lubrication Guide WHAT 1Rear Axle Bearing 2Front Wheel Bearings (2WD) 3Front Wheel Bearings (4WD) 4Swing Arm Bushings 5Ball Joints 6Front Arm Pivot Shafts 7Tie Rod Ends 8Steering Post Bushings LUBE RECQMMENDED GreaseGreaseATFType GreaseGreaseGreaseGreaseGreaseMETHOD Grease gun, fitting Remove, clean, hand pack Remove, clean, and refill to 4:00 level Grease gun, fitting Grease gun, fitting on back side of struts Grease gun, fitting Lift boot up, apply grease Grease gun, fitting or remove cotter pin, slide up post, hand grease and reassemble Fill oil tank Fill oil tank to proper level To check plug Fill to full level on dipstick Fill to full level on dipstick Lube into cable housing Lube under rollers and between plate of moving chain Type 1- 181 (3.5mm) from top of reservoir Type 11- 141 (7 mm) from top of reservoir Fill to bottom of fill hole threads 70 to 75 CCs as indicated on dipstick Grease gun, fitting WHEN Semi Annually50 hrsSemi Annually50 hrsSemi Annually50 hrsSemi Annually50 hrsSemi Annually50 hrsSemi Annually50 hrsSemi Annually50 hrsSemi Annually50 hrsor 1000 miles; whichever comes first When refueling When refueling Change Annually100 hrsChange Annually100 hrsChange Annually -100 hrsSemi Annually50 hrsAs Required years years Change Annually -Housing 100 hrsChange Annually -Housing 100 hrsSemi Annually50 hrs