1985-1995 Polaris ATV and Light Utility Hauler Service Manual, Page 71Get this manual
BODY, STEERING AND SUSPENSION
Camber and Caster Adjustment
NOTE: Camber and caster on 1989 to current models is not adjustableCamber Adjustment 1985,1986,1987 Two Wheel Drive Models
Before proceeding with this adjustment be sure tires are properly inflated Place machine on smooth level surfaceSet handlebars in straight ahead position and adjust tie rods to visually close setting on toe alignmentNOTE: The steering frog can be used as an indicator of whether the handlebars are straightThe frog should always paint straight back from the steering post4Place carpenters square along side the wheel as shown
5Loosen strut to spindle attaching bolts and adjust wheel inward or outward so there is difference of approximately 0400" (1 cm) between top and bottom measurements as shown in drawingNOTE: This equals positive camber6After adjusting, re-torque attaching bolts to 50 ftIbs(6.9 kgm)7Repeat procedure on opposite wheelCaster Adjustment 1987 and 19884 Wheel Drive Models