Kawasaki Prairie 360 KVF-360 Factory service manual, Page 376Get this manual
16-60 ELECTRICAL SYSTEM Actuator Control System
Check 6Controller Unit Inspection
Be sure the battery is fully charged
Remove: Frame chapter) Seat (see Connect: Controller Connector [A]
Hand Tester [B] (range: DC 10 V) Connector (O) Terminal [2] Tester (+) Tester () Connector (BKY) Terminal [10] Install the needle adapters on the tester leadsSpecial ToolsHand Tester: 570011394 Needle Adapter Set: 570011457
Turn ON the ignition switchvoltage for the actuators Measure the controller output
Controller Output Voltage (to Actuators) Standard: 4.8 0.2 V
If the reading is not standard, replace the actuator controller unit
Disconnect the speed sensor lead connector Connect: Connector [A] Controller
Hand Tester [B] (range: DC 10 V) Tester (+) Connector (P) Terminal [5] Tester () Connector (BKY) Terminal [10] Install the needle adapters on the tester leads