Kawasaki Prairie 360 KVF-360 Factory service manual, Page 375Get this manual
ELECTRICAL SYSTEM 16-59 Actuator Control System
Check 4Speed Sensor Inspection
Be sure the battery is fully charged
Support the vehicle on stand or jack so that the wheels are off the ground Remove: Frame chapter) Seat (see Connect: Connector [A] Controller
Hand Tester [B] (range: DC 25 V) Connector (P) Terminal [5] Tester (+) Tester () Connector (BKY) Terminal [10] Install the needle adapters on the tester leadsSpecial ToolsHand Tester: 570011394 Needle Adapter Set: 570011457
ignition switch Turn ON thewheel, measure the voltage Spin rear
Speed Sensor Output Voltage Standard: repeat from to V
If the reading is not standard, replace the speed sensorCheck 52WD4WD Shift Switch Inspection