Kawasaki Prairie 360 KVF-360 Factory service manual, Page 103Get this manual
ENGINE TOP END 4-31 Cylinder and Piston
CylinderPiston Wear
difference in cylinder wear in different direction, take Since there is aand front-to-back measurement at each of the side-to-side locations (total of measurements) shown in the figureIf any of the cylinder inside diameter measurements exceeds the service limit, replace the cylinder20 mm (0.79 in [A] 40 mm (1.57 in [B] 10 mm (0.39 in [C]
Cylinder Inside Diameter 80.012 mm (3.14963.1501 in, Standard: 80.000 and less than 0.01 mm (0.0004 in difference between any two measurements Service Limit: 80.10 mm (3.154 in, or more than 0.05 mm (0.0020 in difference between any two measurements
the piston mm (0.20 in Measurethe bottom diameter [A] of each piston to the direction[B] up from of the piston at right angle of the piston pinPiston Diameter Standard: Service Limit: 79.967 mm (3.14773.1483 in 79.952 79.80 mm (3.142 in
If the piston diameter is less than the service limit, replace it