2008 Kawasaki Teryx 750 Service Manual, Page 522Get this manual
ELECTRICAL SYSTEM 16-63 Actuator Control System
the vehicle Supportthe groundon stand or jack so that the wheels are off Connect: Connector [A] Controller Hand Tester [B] (range: DC 25 V) Tester (+) Connector (WR) Terminal [15] Tester () Connector (BKY) Terminal [10] Install the needle adapters on the tester leadsON the ignition Turn rear wheel as switchrotationSpin After the wheels stop forward second elapses, turn OFF the ignition switchand one seconds elapses, measure the controller output After twofor the engine brake actuator until the actuator voltage stopsController Output Voltage (to engine brake actuator) Standard: 12 Special ToolsHand Tester: 57001-1394 Needle Adapter Set: 57001-1457
If the reading is not standard, check the forwardreverse detecting sensorIf the forwardreverse detecting sensor is normal, replace the actuator controller unit