2008-2010 Kawasaki KFX450R Factory Service Manual, Page 384Get this manual
STEERING 14-15 Handlebar
Install the handlebar so that the angle of the handlebar is parallel [A] to the steering stem
on the Install the handlebar [A]the bothhandlebar holder so that the protruded scales of side adjust to the same width [B]
Install the handlebar clamps [A][1 4] following the Tighten the handlebar clamp bolts tightening sequence as shownTorqueHandlebar Clamp Bolts: 29 Nm (3.0 kgfm, 21 ftlb)
If the holder is correctly installed, there will be even gaps [B] at the front and rear side
on the Install the left switch housing [C] or less.handlebar [B] so that the opening angle is 40 [A]