2008-2010 Kawasaki KFX450R Factory Service Manual, Page 379Get this manual
14-10 STEERING Steering
Install: and Knuckle Joint Nuts [A] Washers Tighten:
pins Install the new cotterparts[B] and bend its both endsInstall the removed
TorqueKnuckle Joint Nuts: 29 Nm (3.0 kgfm, 21 ftlb)
Tie-rod Removal
Remove: (see Wheel Removal in the WheelsTires Front Wheels
chapter) Cotter Pin, Tie-rod End Nuts [A] and Washers Tie-rod [B]
CAUTION
When removing the tie-rod, be careful not to bend itDo not loosen the locknuts [C] at the end of the tie-rod adjusting sleeve, or the toe-in of the front wheels will be changedthe tie-rod end [A] using suitable joint remover RemoveSteering Knuckle Removal)[B] (see