2007-2009 Kawasaki KFX50 service manual, Page 190Get this manual
13REAR WHEELSWING ARMHYDRAULIC BRAKE REAR AXLE INSTALLATION Reverse the "REAR AXLE REMOVAL" proceduresInstall the rear axle hubApply grease onto the oil seal lips, bearings and bushes
At this time, the rear axle hub should not be tightened completelyFinal tightening is done after the chain slack adjustmentDrive Sprocket Install the driven sprocket so that the stepped side faces outwardInstall the rear axleInstall the sprocket holder and boltsTorque: 26 Nm (2.7 kgfm, 20 lbfft) Install brake disk and collarsInstall wheel hub (see page 13-5) and rear wheel (see page 13-4)Adjust drive chain slack(Refer to the "DRIVE CHAIN SLACK INSPECTION" section in the chapter Approximately: 1020 mm (0.40.8 in)