2005 Kawasaki KAF400 Mule 600 and Mule 610 4x4 Service Manual, Page 91Get this manual
ENGINE TOP END 4-9 Cylinder Head
Push Rod Inspection
push in are as Place theasrocker armand setroddial blocks that the rod far apart possible, gauge [A] on at point halfway between the blocksTurn the rod to measure the runoutThe difference between highest and the lowest dial readings is the amount of runoutIf the runout exceeds the service limit, replace the rodRocker Arm Push Rod Runout Service Limit: TIR 0.5 mm (0.02 in
Valve Mechanism RemovalInstallation
Remove: Head (see Cylinder Head Removal) Cylinder Support the valve head in the combustion chamber with suitable block To remove the collets [A], push down the valve retainer [B] with thumbs and remove the collets Remove the valve retainer, spring [C] and valve [D] Remove the stem seals [A]NOTE