2005-2009 Kawasaki Brute Force 650/KVF 650 4x4 Service Manual, Page 457Get this manual
17-78 ELECTRICAL SYSTEM Actuator Control System
Support the vehicle on stand or jack so that the wheels are off the ground Connect: Controller Connector [A] Hand Tester [8] (range: DC 25 V) Connector (WR) Terminal [15] Tester (+) Connector (8K1Y) Terminal [10] Tester (-) Olnstall the needle adapters on the tester leadsSpecial ToolsHand Tester: 57001-1394 Needle Adapter Set: 57001-1457
'5 (j)] [IT] IT! []] Q] ITJ ITJ II]
IlllIITlIlll
HP 23008 BS1 C
Turn ON the ignition switch'Spin rear wheel as forward rotation After the wheels stop and one second elapses, turn OFF the ignition switch After two seconds elapses, measure the controller output voltage for the engine brake actuator until the actuator stopsController Output Voltage (to engine brake actuator) Standard:12 V
If the reading is not standard, check the forwardreverse detecting sensor If the forwardreverse detecting sensor is normal, replace