2005-2009 Kawasaki Brute Force 650/KVF 650 4x4 Service Manual, Page 275Get this manual
12-34 FINAL DRIVE Front Final Gear Case
Variable Differential Control Cable Installation
Lubrication the variable differential control cable before installation Route the cable correctly according to the Appendix chapter
A WARNING
Operation with an improperly adjusted, incorrectly routed, or damaged cable could result in an unsafe operating condition
Tighten:
TorqueVariable Differential Control Cable Locknut [A): 17 N'm (1.7 kgfm, 12 ft-lb)
Check the variable differential control lever play (see Variable Differential Control Lever Play Inspection in Periodic Maintenance chapter)
Variable Differential Control Cable Lubrication
Whenever the variable differential control cable is removed, lubricate the cable as follows: Apply small amount of multi-purpose grease to the cable (both ends) Lubricate the cable with penetrating rust inhibitor through the pressure cable luberGC040114S1 C