2005-2009 Kawasaki Brute Force 650/KVF 650 4x4 Service Manual, Page 234Get this manual
WHEELSTIRES 11-7 Wheel Alignment
Repeat the straightedge procedure on the other side of the vehicleNow the front wheels are parallel to each other and to the center line of the vehicleFront Wheel [A] Vehicle Center Line [B] Parallel each other [C] Straightedges [D] Rear Wheels [E] Go on to the Toe-in Inspection procedureHJ04016BS1 C
Toe-in Inspection
Apply heavy coat of chalk or paint line near the center of the front tires Using needle nose scriber, make thin mark near the center of the chalk coating while turning the wheel
HJ04017BS1
With the front wheels on the ground, set the handlebar straight ahead At the level of the axle height, measure the distance between the scribed or painted lines for both front and rear of the front tires Subtract the measurement of the front from the measurement of the rear to get the toe-inIf the toe-in is not in the specified range, go on to the Toe-in Adjustment procedureToe-in of Front Wheels Standard:20 mm (00.79 in at 1G