2004 Kawasaki KVF750 4x4, Service Manual., Page 169Get this manual
6-10 CONVERTER SYSTEM Torque Converter
Torque Converter Cover Installation
lever Check the actuatorCover assembly installation length (see Torque Converter Assembly)Fit the trim seal into the converter cover Set the trim seal juncture in the area [A] when insert the trim seal in the cover[B] 10 mm (0.39 in
Check:Belt Failure Detection Switch (see Switch InspecDrive
tion section in Electric System chapter) Set [A] the switch lever [B] to the ON mark side [C]Converter Cover [D] Front [E]
The failure detection system is activated when the switch is in the ON positionThis is the normal running modeEngine rpm is limited when the switch is in the OFF position