2004-2006 Kawasaki Prairie 700 4x4, KVF 700 4x4 service manual, Page 321Get this manual
13-10 BRAKES Master Cylinder
Master Cylinder Removal
Remove: Brake Hose Banjo Bolt [A] Master Cylinder Clamp Bolts [B] Master Cylinder [C]
CAUTION
Brake luid quickly rui ns painted surface; any spilled fluid should be completely washed away immediately
Master Cylinder Installation
The master cylinder clamp must be installed with the "UP" mark [A] upwards Tighten the upper clamp bolt first, and then the lower clamp boltThere will be gap at the lower part of the clam after tightening TorqueMaster Cylinder Clamp Bolts: 8.8 N' (0.90 kgf-m78 in'lb)
Use new flat washer on each side of the brake hose fitting, and tighten the banjo boltTorqueBrake Hose Banjo Bolt: 25 N'm (2.5 kgf-m, 18 ft'lb)