1995-2004 Kawasaki Lakota 300, Lakota Sport, KEF300 Service Manual, Page 155Get this manual
9-10 FINAL DRIVE
Rear Axle Bearing Housing Removal
Remove the rear axle Loosen the drive chain adjuster clamp bolts and nuts Remove the left-hand circiip [AJ on the housing using the outside circlip pliersSpecial Tool Outside Circlip Pliers: 57001-144
.Tap the bearing housing and caliper bracket out of the swingarm
Rear Axle Bearing Removal
Remove: Rear Axle Bearing Housing Pry the spacer pipe toward one side Drive the bearing out by tapping on the exposed portion of the spacer pipe end with hammer and metal rodThe grease seal [AJ may be tapped out with the bearing [8] Insert the spacer pipe into the hub assembly Drive out the remaining bearing and grease seal by tapping on the spacer pipe with suitable driver Deburr the spacer pipe as needed