1987-2004 Kawasaki Mojave KSF250 Service Manual, Page 146Get this manual
BRAKES 1111 -Remove the clamp bolts and take off the master cylinderImmediately wipe up any brake fluid that spills
Rear Master Cylinder Removal
-Remove the reservoir tank by taking out the mounting bolt
ATighten upper clamp bolt first
BArrow Mark
-Use new flat washer on each side of the brake hose fitting, and tighten the banjo 'bolt to the specified torque (see Exploded View)
AMounting Bolt
BReservoir Tank
Rear Master Cylinder Installation Notes
-Remove the master cylinder cap and diaphragm, and empty out the brake fluid-Remove the banjo bolt connected to the rear caliper-Separate the master cylinder from the brake pedal by removing the pedal pin joint-Remove the master cylinder by taking out the mounting bolts-Use new flat washer on each side of the brake hose fitting, and tighten the banjo bolt to the specified torque-Run the brake hose according to the Cable and Harness Routing section in the General Information chapter