1987-2004 Kawasaki Mojave KSF250 Service Manual, Page 106Get this manual
CRANKSHAFTTRANSMISSION
elnstall the output shaft oil seal and bearing into the left crankcase half as shownOutput Oil Seal, Ball Bearing Installation
4 APry Point (front) BPry Point (rear)
eTap the output shaft end lightly with plastic mallet if necessaryeRemove the collar at the output shaft from the left crankcase halfCrankcase Assembly eAny oil seal that is removed is damaged and must be replaced with new oneelnstall the ball bearings and oil seals using press and the bearing driver set (special tool: PIN 57001-1129)
1Left Cran kcase 2Ball Bearing