1987-2004 Kawasaki Mojave KSF250 Service Manual, Page 44Get this manual
COOLING SYSTEM Mechanical Seal Removal
eCiean the sliding surface of the mechanical seal with high flash-point solvent, and apply little coolant to the sliding surface to give the mechanical seal initial lubricationeApply coolant to the surfaces of the rubber seal and sealing seat, and install the rubber seal and sealing seat into the impeller by pressing them by hand until the seat stops at the bottom of the hole
1Tap 2Metal Rod
3Oil Seal 4Mechanical Seal
Mechanical Seal Installation
oSince the replacement mechanical seal has an adhesive coated body, do not apply liquid gasket to the exterior surface of the bodyeApply high temperature grease and install the oil seal as shownePress the seat into the hole by using bearing driver set (special tool) until it stops at the bottom surface of the engine cover