1987-2004 Kawasaki Mojave KSF250 Service Manual, Page 26Get this manual
FU EL SYSTEM eRemove the choke lever and free the choke cable upper end from the leverePull off the retaining ring and free the choke cable housing from the switch caseOUse the pressure cable luber (special tool: PIN K56019021) to lubricate the choke cable
Choke Cable Inspection eWith the choke cable disconnected at both ends, the cable should move freely in the cable housing (see General Lubricatio.n in Appendix chapter)
Carburetor
Idle Speed Adjustment eAdjust the pilot screw if necessary (see Carburetor Pilot Screw Adj ustment)eStart the engine and warm it up thorough-lyeTurn the idle adjusting screw to obtain the slowest smooth idle speedeCheck that the idle adjusting screw stops against the throttle pulley
ARetaining Ring ePull the cable out of the vehicle
Choke Lever and Cable Installation eChoke cable installation is the reverse of removalNote the followingeLubricate the choke cable before installation (see General Lubrication in Appendix chapter)elnstall the wave washer, plane washer and screw in that order