2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual, Page 219Get this manual
Inspect ball joint ends for wear or looseness, if excessive, replace For installation, reverse the removal procedurePay attention to the following detailsAssemble bearing to bearing flangesFlange collars of bearing flange must be facing outward
For the installation, reverse the removal procedurePay attention to the following detailsAt the time of reinstallation or of the new tie-rod(s) installation, screw threaded end of tie-rod into ball jointThe maximum length for tie-rod groove to ball joint end must be the value in the following chart:
Install carriage bolts no23, apply Loctite 243 on threads
A 20 2532 316
V01I0YA
V01i0ya2.EPS