2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual, Page 185Get this manual

2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual, Page 185

MODE section, task 5 The GBPS is located on rear of engine
Refer to SENSORS TESTS section
Unplug GBPSRemove screws and reinforcementsPull GBPS
For installation, reverse the removal procedurePay attention to the following details: Check O-ring and change if necessaryAlign interior of GBPS with engine shaftV01C2LC
V01c2Lc2.EPS

Place connector on topSecure with screws and lock washersApply Loctite 243 on threads Torque screws to Nm (18 lb-inRemove bolt retaining VSSPull VSS out of engine Calibrate GBPSRefer to DIAGNOSTIC CALIBRATION MODE section, task 4
The VSS is located on front of engine

Back to 2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual