2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual, Page 148Get this manual

2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual, Page 148

For insertion of signal contact, make sure the wedge lock is in the open position
Insert contact into appropriate circuit cavity and push as far as it will goPull back on the contact wire to be sure the retention fingers are holding the contactAfter all required contacts have been inserted, the wedge lock must be closed to its locked position
F00H0RA

F00h0ra.EPS

Before extraction, push wire forward to relieve pressure on retaining tabInsert 4.8 mm (0.189 in) wide screwdriver blade inside the front of the contact cavityF00H11A

Back to 2004 John Deer Buck Utility ATV 500, 500EX and 500EXT Service Manual