2009-2012 Honda MUV700 Big Red Service Manual, Page 484Get this manual
FRONT DRIVING MECHANISM Install new oil seal so that it is flush with the gear case, being careful not to damage the lipTOOLS: Driver Oil seal driver attachment 07749-0010000 07JAD-PH80101
Pack the seal lips of the dust seal with grease
PINION NEEDLE BEARING
Rotate the stopper ring until its end appears in the access hole Strike gently near the end of the ring with punch to bend the end upward Grasp the end of the ring with needle-nosed pliers and pull the stopper ring out through the access holeBe sure to wear heavy gloves to avoid bums when handling the heared gear caseUs ing rorch to hear the gear case may cause warpage
Heat the gear case to about 80C (176F) and remove the needle bearing, using the special tools TOOLS: Remover head, 15 mm Remover shaft, 15 mm Bearing remover15 mm Remover weight 07936-KC10200 07936-KC10100 or 07936-KC10500 07741-0010201 or 07936-371020A (U.S.A only) or 07936-3710200 (U.S.Aonly)