2009-2012 Honda MUV700 Big Red Service Manual, Page 342Get this manual
DRIVETRAIN SYSTEM BEARING REPLACEMENT Remove the crankshaft bearing using the special tools TOOLSBearing remover, 17 mm Remover handle Remover weight 07936-3710300 07936-3710100 07741-0010201 or 07936-371020A or 07936-3710200 (U.S.A only)
Dr ive the output shaft bear ings out of th crankcase cover
Remove the snap ring, washerand the seal collarCoat new O-ring with engine oil and instal it into the groove in new collarBe careful no 10 damage (he mner surface 01 rhe collar
Install th collar unti it is seatedInstall the washer and he snap ring into the cover groove properly
Drive new bearings in with the marked sid facing upTOOLS: Crankshaft bearingDriver Attachment, 42 47 mm Pilot, 17 mm Output shaft bearingDriver Attachment, 42 47 mm Pilot, 25 mm