2009-2012 Honda MUV700 Big Red Service Manual, Page 320Get this manual
DRIVETRAIN SYSTEM
DRIVETRAIN DTC TROUBLESHOOTING
NOTE: The connector location and the necessary parts to disconnect the connector (page 14-13) Perform inspection with the ignition switch turned to OFF (0unless otherwise specif ied After trou bleshooting, erase the DTC (page 13) and test-drive the vehicle to be sure that the system is normal
DTC 4-1 (AfT CLUTCH PC SOLENOID VALVE LOW INPUT), DTC 4-3 (AfT CLUTCH PC SOLENOID VALVE DRIVE CIRCUIT)
Before starting the troubleshooting, check the AfT clutch PC solenoid valve 2P lack connecto fo loose or poor contacts, and recheck the DTC1Recheck DTC Test-drive the vehicle and stop the eng ine Recheck the current DTC with the HDS pocket tester
Is DTe 41 or 4-3 indicated?
- GO TO STEP 2- Interm ittent fai lure
2AfT Clutch PC Solenoid Valve Inspection Turn the ignition switch to OFF (0 )Disconnect the AfT clutch PC solenoid valve 2P black connector Measure the resistance between the solenoid valve side 2P connector term inalsStandard: 5.15.7 (20C68F)