2009-2012 Honda MUV700 Big Red Service Manual, Page 220Get this manual
ENGINE REMOVALlNSl ALLA liON Install the mounting rubbers onto the upper mounting bushing in the hange bracket with the large 1.0side facing inInstall the hanger bracket with the 10-mm hanger bolt (from he front side) and nutInstall the two 8-mm hanger boltsAfter inst alling al the mounting fasteners and seat themtighten the fasteners in order as follows:left and right lower engine hanger nuts TORQU E: 54 N' (5.5 kgf40 Ibfftleft and right lower hanger bracket bo lts
TORQU E: 26 N'm (2.1 kgfm20 Ibfftframe side upper engine hanger bo lt
TORQUE: 54 Nm (5.5 kgfm40 Ibf.ft) engine side upper engine hanger bolts
TORQUE: 32 N'm (3.2 kgf24 Ibfft) Coat new O-ring with molybdenum isu lfide grease and insta ll it into the outPLlt shaft grooveApp ly molybdenum disulfide grease to the propeller shaft joint splinesMove the gear case assembly forward for maximum clearance between the shaft jo int and output shaftEngage the shaft joint over the output shaft and move the ear case assembly rearward