2009-2012 Honda MUV700 Big Red Service Manual, Page 92Get this manual
FRAMEBODY PANELSEXHAUST SYSTEM BELTRETRACTOR Unlock the cargo bed by pulling up on the release lever and then raise the bedRemove the following:anchor cover (by sliding it down)upper and lower anchor bolt (16 mm head)retractor bolt (washer-bolt)seat belt assembly
Route the belt Installation is in the reverse order of removalbehmd the OPS as shown
ANCHOR BOLT
Before installing, check that the retractor locking mechanism functionssee below Assemble the washers of the anchor bolt properly if it was disassembled When installing the retractor, align the locating pin with the hole in the frame When installing the anchor boltsmake sure there no twists or kinks in the beltTORQUE: 32 Nm (3.3 kgfm24 IbUt)
After installingcheck the following:the belt does not lock when pulled slowly and it will retract automatically when releasedThe seat belt is designed to lock only during sudden stop- each anchor for free movement on the anchor boltIf necessary, remove the anchor bolt and check that the washers and other parts are not damaged or improperly installed